With all of the changes it was time to move some control panels around. I removed the old panel for Portland to be used for Brewer. Then I removed the Bangor/Brewer panel for use for both staging areas.
The new Brewer panel was redesigned for how Brewer looks now. Some of the electronics for Katahdin had to be moved into this panel. It now sits where the upper staging panel used to be. I needed to go into JMRI and make many changes in the program so it would work properly.
The new staging panel face is in the process of being made. There will be an upper staging and lower staging section. Each section will have 12 push buttons for local control and lights so you what track is selected. There will be a local enabled light and a red and green light to tell the engineer if he can proceed or not.
The new Brewer panel was redesigned for how Brewer looks now. Some of the electronics for Katahdin had to be moved into this panel. It now sits where the upper staging panel used to be. I needed to go into JMRI and make many changes in the program so it would work properly.
The new staging panel face is in the process of being made. There will be an upper staging and lower staging section. Each section will have 12 push buttons for local control and lights so you what track is selected. There will be a local enabled light and a red and green light to tell the engineer if he can proceed or not.
The above panel will be used for staging.
No comments:
Post a Comment